Xerox 460 정보 매뉴얼 - 페이지 8

{카테고리_이름} Xerox 460에 대한 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 460 13 페이지. Macintosh driver information
Xerox 460에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (38 페이지)

Page 8

Section IV - Driver Accessibility through PageMaker 6.5

and QuarkXpress

Accessing the Custom Driver through PageMaker

Do the following steps to access the DC 265/255/240 or 490/460 custom Macintosh driver

interface in Macintosh PageMaker 6.5.

NOTE: Follow these steps if you use the Xerox DC 265/255/240 or 490/460 Document

Centre custom Macintosh drivers with the custom PPDs. Do not follow this procedure if you

are using the Adobe PostScript driver or the LaserWriter driver with the generic PPDs.

1. In PageMaker, press the Option key and select [File: Print].

2. Select [Setup].

3. Select <OK>. This opens the Xerox driver interface.

4. In the pulldown menu, select [Xerox Options].The Xerox custom interface appears.

5. Select [Extended Options] to enable Document Centre options such as secure print,

sample set, banner sheet toggle on/off, and cover selections.

Paper Trays Cannot be Selected from PageMaker with Generic Driver

(LaserWriter or Adobe) and Xerox Generic PPDs

Problem:

PageMaker does not pull the configuration information from the setup in the Chooser for the

DC 265/255/240 or 490/460. You must configure the device options from within the

application as well as in the Chooser.

Solution:

To configure the driver (LaserWriter, Adobe driver), do the following steps:

1. In the Chooser select the LaserWriter or Adobe printer driver.

2. Select [Setup], [Select PPD] and select the generic or generic for DocuTech PPD for

your Document Centre system.

3. Select [Configure].

4. Select [Install] for the appropriate features (Finisher or Tray 6) for your Document

Centre.

5. Open PageMaker and verify that the Page Setup has the appropriate paper size

selected.

6. Select [File: Print].

7. Ensure that one of the generic PPDs or generic for DocuTech PPD's is selected.

8. Select [Features] to configure the appropriate features for your Document Centre.

NOTE: The features are listed in a scrolling menu. The Finisher and Tray 6 options are at

the bottom of the list.

9. Select [Paper].

10. Select the paper size and the corresponding tray. You are now ready to print.

Document Centre Technical Support Operations

dc99cc0135