Xerox 4595 고객 기대치 문서 - 페이지 18
{카테고리_이름} Xerox 4595에 대한 고객 기대치 문서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 4595 33 페이지. Copier/ printer with copy-server and controller
Xerox 4595에 대해서도 마찬가지입니다: 운영자를 위한 매뉴얼 (1 페이지), 소개 (4 페이지), 빠른 참조 매뉴얼 (6 페이지), 빠른 참조 매뉴얼 (4 페이지), 브로셔 및 사양 (4 페이지)
페이지 인쇄
Optional Oversized High Capacity Feeder (OHCF)
Section
Nominal Voltage
Amperage
Cycles (single phase)
Xerox Receptacle Part No.
Receptacle NEMA Part No.
Power Cord Length
Receptacle Diagram
(XNAonly, All others: Flying leads)
Power
NOTE: Surge protection for the OHCF is strongly recommended and is the responsibility of the
customer.
The following illustration shows the space requirements and service space envelope for the Xerox
4595 with the optional Finisher/Folder and OHCF installed. For other configurations, consult the
Module Dimensions chart.
Note 1: The dimensions shown are absolute minimums.
Note 2: 78" (1981 mm) minimum height clearance in service envelope.
Note 3: Location of left rear corner of main processor should be marked with tape for delivery personnel.
(See diagram above)
Note 4: If there is no HCF or OHCF attached, then the Multi-Sheet Inserter, in the closed position (3.3"/83
mm), must be calculated in the space requirements.
Service/ Operational Space
Rear of Main Processor/System
Front of Main Processor
Front of HCF and Finisher/Folder
Front of OHCF and Finisher/ Folder
Side of System
Height of System
Moveable installation dimensions can be used when the system is installed on a hard surface
1
(concrete, wood, and/or with a mobility plate).
Specification
100-240 VAC, single phase (+6% to -10%)
15
50/60 HZ
600S3704
5-15R
10 feet/3 meters
60 W maximum
Moveable Installation
10"/254 mm
54"/1372 mm
38"/965 mm
38"/965 mm
24"/610 mm
78"/1981 mm
Stationary Installation
1
24"/610 mm
54"/1372 mm
38"/965 mm
38"/965 mm
24"/610 mm
78"/1981 mm
18