Xerox DocuPrint C3055 DX 설정 매뉴얼 - 페이지 17

{카테고리_이름} Xerox DocuPrint C3055 DX에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuPrint C3055 DX 33 페이지. Internal hard disk
Xerox DocuPrint C3055 DX에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (16 페이지), 설정 매뉴얼 (20 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

Alphanumeric

Sets the font for single-byte characters (ANK) to [Roman] (default) or [Sans Serif].

Note

• This setting is not affected by extension commands sent from users.

Refer to

• "1.2 About Fonts" (P. 9)

Page Position

Sets the paper position by enabling or disabling the cut sheet feeder setting.

The following options are available:

[CSF Off] (default)

Disables the cut sheet feeder setting.

[CSF On]

Enables the cut sheet feeder setting.

Adjust Position

This feature allows you to adjust the printable area in vertical or horizontal direction and

move the margins.

Up/Down Adj

Adjusts the position of the printable area in vertical direction. The position can be adjusted

within the range of -250 to 250 mm in increments of 1 mm. The default is [0mm].

If entering the value in inches, enter it within -9.8 to 9.8" in increments of 0.1". The default

is [0.0"].

Left/Right Adj

Adjusts the position of the printable area in horizontal direction. The position can be

adjusted within the range of -250 to 250 mm in increments of 1 mm. The default is [0mm].

If entering the value in inches, enter it within -9.8 to 9.8" in increments of 0.1". The default

is [0.0"].

Note

• The part of data that falls outside the printable area will not be printed even if you adjust the position of

the printable area. Also, the part of data that falls outside the printable area due to the adjustment of the

printable area will not be printed.

• Holding down the <

> or <

pressing the <

> and <

Ruled Line

Sets the method for printing double-byte ruled lines.

The following options are available:

[Image] (default)

Prints double-byte ruled lines as images. This eliminates misalignment between ruled lines

and images.

[Font]

Prints double-byte ruled lines in built-in fonts. This gives a uniform appearance to ruled lines

and texts.

Print Control

Skip Blank Pages

Sets whether or not to skip blank pages during printing.

The following options are available:

[On] (default)

Skips blank pages.

> button scrolls through the options in a circular fashion. Simultaneously

> buttons displays the default value.

2.2 Setting the ESC/P Mode Menu