Xerox DocuPrint N32 기술 지침 - 페이지 4

{카테고리_이름} Xerox DocuPrint N32에 대한 기술 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuPrint N32 10 페이지. Xerox docuprint n24: supplementary guide
Xerox DocuPrint N32에 대해서도 마찬가지입니다: 빠른 설치 (10 페이지), 기능 설명서 (15 페이지), 소모품 매뉴얼 (2 페이지)

페이지 인쇄

Step 17

Install the drum axle hubs on

each side of the waste hopper

and install the screws that hold

the axle hubs.

(See Photos 22 & 23)

Photo 22

Photo 23

Step 18

Rotate the drum 4-5 revolutions

to ensure that the wiper blade

is cleaning the drum correctly.

Using a lint free cloth wipe the

padding powder off the PCR.

Set the waste hopper aside and

cover.

Photo 24

Photo 25

Photo 26

Photo 27

Photo 28

Xerox N24/32/40 Technical Instructions

Step 19

Remove the screw that holds the mag

roller end cap on the gear end of the

mag roller. (See Photo 24) Remove the

end cap.

Step 20

Remove the mag roller drive gear and

the stabilizing bushing from the end of

the mag roller. (See Photo 25)

Step 21

Lift the gear end of the mag roller up

and remove the roller from the contact

end of the hopper. (See Photo 26)

Step 22

Remove the mag roller bearing and the

bushing from the gear end of the mag

roller. (See Photo 27)

NOTE: A locking washer keeps the

mag roller bearing and bushing on the

contact end of the mag roller in place,

it is not necessary to remove them.

Clean the bearings with a lint free cloth

and alcohol.

Step 23

Using dry compressed air or a vacuum,

clean the toner off the mag roller.

NOTE: Clean the mag roller using a mag

roller cleaner and a lint free cloth.

Step 24

Remove the two screws holding the

doctor blade. (See Photo 28) If you plan

to reuse the doctor blade clean the toner

off the blade using dry compressed air

or a vacuum. Using a lint free cloth and

alcohol wipe off the doctor blade.