Xerox Phaser 750DX 서비스 매뉴얼 - 페이지 21

{카테고리_이름} Xerox Phaser 750DX에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 750DX 40 페이지. Digital color printer / copier
Xerox Phaser 750DX에 대해서도 마찬가지입니다: 사양 (2 페이지), 브로셔 및 사양 (4 페이지), 참조 매뉴얼 (8 페이지), 매뉴얼 (9 페이지)

페이지 인쇄
Xerox Phaser 750DX 서비스 매뉴얼
Status
Code
Tray Paper
The control logic has sensed that the the paper size is not being detected correctly.
Size
Initial action:
Sensing for
Go to the Paper Tray which was selected on the Control Panel and verify that the Paper Size Indicator is set
Tray 1, Tray
to the correct paper size that is loaded in the Paper Tray.
2, Tray 3,
Tray 4, or
Go to the Paper Tray which was selected on the Control Panel and verify that the paper is loaded correctly.
the Bypass
NOTE : Check for obvious damage, missing or broken Drive Motor gear assemblies and drive belts. These
Tray
items may cause a sensor failure to be displayed as an operator error message.
If the problem still exists:
Place a service call.
08-105,
The control logic sensed a timing problem from the Feed Out sensor for Tray 1 (08-105), Tray 2 (08-110), Tray 3 (08-
110, 115,
115) or Tray 4 (08-120).
120
Initial action:
For the appropriate tray, check the Tray Feed Out Sensor actuator for freedom of movement and proper
installation.
Check for proper installation of the appropriate Paper Guide.
For the appropriate tray, check the Feed Sensor, Nudger, Retard and Feed Rolls shaft, for cleanliness,
damage and excessive wear.
Clean the Feed, Retard and Nudger Rolls with a damp cloth (water) (REP 5.22) (REP 5.24).
Fan the paper or replace the paper with a new ream of paper.
If the problem still exists:
Place a service call.
5750 DocuCare Service Manual
Description/Direction
5/98
2-21
Fault Code Procedures