Xerox Secure Access Unified ID System 설치 매뉴얼 - 페이지 31

{카테고리_이름} Xerox Secure Access Unified ID System에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Secure Access Unified ID System 36 페이지.

Mount the Secure Access Authentication Device

Print out the

Configuration Tear Sheet

You need this information when you configure communication between devices on the Secure Access

Server.

1. Lay the Authentication Device on the floor, behind and on the input side of the MFP. The device

should be placed in an unobtrusive location, but ensure that you have enough cable length (6')

to connect to the Card Reader.

2. Mount the Card Reader on the shelf on the left side of the MFP front panel using the supplied

Velcro strip. If you have the Convenience Stapler option, place the Card Reader to the right of the

stapler so the Card Reader is between the stapler and MFP. Ensure the Document Handler top

cover can be opened without being obstructed by the Card Reader before attaching the Velcro

strip.

3. Use the Tear sheet to record the IP and MAC Address of the Authentication Device as well as the IP

Address and Hostname of the MFP that this Authentication Device will control.

Note:

Refer to the MFP System Administration CD for other suggested mounting locations.

on page 35. As you work, complete the columns on this sheet.

Secure Access

Authentication Device

Card

Reader

Xerox MFP

Setting Up the Secure Access Hardware

Xerox Secure Access Installation Guide