Xerox Secure Access Unified ID System 설치 매뉴얼 - 페이지 29

{카테고리_이름} Xerox Secure Access Unified ID System에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Secure Access Unified ID System 36 페이지.

Manually Assign the IP Address

Follow these instructions only if you are not using a DHCP server to set the IP Address of the

Authentication Device OR if you are using a DHCP server, but prefer to use static IP Addresses rather

than using option 230.

When first powered up, the Authentication Device looks for a DHCP server to secure an IP Address. If

no DHCP server is found, the devices switches to static communication and defaults to a static IP

Address of 192.168.2.1. You can use an Ethernet cable to connect a system (for example, a laptop) to

each Authentication Device, then use a Web Admin tool to change the IP Address, and enter the DCE

Server IP Address.

Print out the Configuration Tear Sheet found on page 32 before you start. Use this sheet to record the

IP addresses you assign to each Authentication Device.

Configure the Laptop:

The system running the Web Admin tool must recognize the static IP Address before you can access

the Web Admin tool.

1. On the system (laptop) that will run the Web Admin tool, select Network Connections > Local

Area Connection > Properties.

2. Double-click Internet Properties (TCP/IP), then click Advanced.

3. In the IP addresses section, click Add.

4. Enter the following:

IP Address: 192.168.2.x (where x is an unassigned IP)

Subnet Mask: 255.255.255.0

5. Click Add to save the changes.

Use the Web Admin Tool to Set IP Addresses:

Perform the following procedure on each Authentication Device.

1. Use a regular Ethernet cable to connect a laptop to the Downlink port on the Secure Access

Authentication Device.

2. To power up the Authentication Device, attach one end of the AC power cable to the

Authentication Device, then plug the other end into an available outlet.

3. Launch a web browser, and type 192.168.2.1 in the Address field.

This is the factory default IP address assigned to the Secure Access Authentication Device.

Note:

For French, select the link provided.

4. Click on the Configure link at the top of the page.

5. Enter the following to login:

User name: deviceadmin

Password: pc_passwd

Setting Up the Secure Access Hardware

Xerox Secure Access Installation Guide