Xerox Secure Access Unified ID System 설치 매뉴얼 - 페이지 27
{카테고리_이름} Xerox Secure Access Unified ID System에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Secure Access Unified ID System 36 페이지.
페이지 인쇄Setting Up the Secure
Access Hardware
This chapter includes:
•
Configure the Authentication Device IP Address
•
Mount the Secure Access Authentication Device
•
Connect the Hardware
•
Mount/Connect the Secure Access USB Card Reader
This chapter provides instructions to perform the physical setup of the Secure Access Hardware. Prior to
setting up any Secure Access Hardware, you must have installed the Secure Access Server software.
Follow the instructions provided in Chapter 4 to complete the Secure Access Server installation.
If you are using a USB card reader for Secure Access skip to page 33.
1. Set the IP Address for each Authentication Device.
2. Mount the Secure Access Authentication Device hardware on or near the MFP.
3. Plug in the power, serial, expansion, and card reader connections.
on page 32
on page 28
on page 31
on page 33
Xerox Secure Access Installation Guide
5
27