Xerox D35 사용자 설명서 - 페이지 38

{카테고리_이름} Xerox D35에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox D35 50 페이지.

페이지 인쇄

Xerox

D35

Slide the friction roller on the bar. Insert the friction roller left side first until it's properly

inserted in the slot. Make sure the left side of the bar is facing up.

Push the left side, then the right side of the roller into place.

Close the friction roller cover when you are finished.

ERROR LIGHT TROUBLESHOOTING CODES

Normal Operation

•

Steady blue: indicates the scanner is ready to scan.

•

Slow flashing blue: indicates the scanner is in low power mode.

•

Rapid flashing blue: indicates the scanner is waking up from low power mode.

•

Steady red: the scanner is busy.

•

Flashing red: the scanner is reporting an error.

Error Codes

The status light indicates the current state of the scanner. If your scanner experiences hardware

problems, the status light turns red and will flash a specific number of times, pause, and then

repeat the same number of flashes. The number of flashes between pauses indicates the

hardware error code. The LED display will also flash an "E" then the error code number that

matches the status light's blinking pattern.

Descriptions of the most common patterns are listed below. In all cases, you should turn off the

scanner and check the scanner setup. Make sure the USB cable is plugged into the scanner and

computer. Make sure the power cord is plugged into the scanner and into a wall outlet. Contact

Xerox Technical Support if you experience a different blinking pattern.

Error Code

Problem

Description

Scanner is not

connected to the

computer

(The LED does not

flash "E" and the

status light

remains blue.)

The scanner was

locked when you

tried to scan.

Paper jam

6-12

Scanner Options, Maintenance and Troubleshooting

Solution

A cable may be loose. Check that the

scanner's cables are correctly

attached to the computer. If the

scanner still does not connect, re-

boot the computer.

Turn off the scanner, slide the locking

tab to the unlocked position, then

turn the scanner back on. If the

problem persists, reboot your

computer.

Open the ADF cover and remove the

jammed page. See Clearing Paper

Jams on page 6-3.

User Guide