Xerox Xerox DocuMate 4790 설정 - 페이지 3

{카테고리_이름} Xerox Xerox DocuMate 4790에 대한 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Xerox DocuMate 4790 6 페이지. Documate series for use with xerox freeflow makeready application
Xerox Xerox DocuMate 4790에 대해서도 마찬가지입니다: 매뉴얼 (24 페이지), 기능 설명서 (26 페이지)

페이지 인쇄

Setting up Xerox

vii) Select each scanner in turn to verify the installation was

successful by scanning a test page.

Do not

select a scanner source with 'WIA' in the listed name.

Results will be less than desirable due to a limited feature set,

and are untested in this environment.

viii) During the test phase, when the 'Scan' button has been clicked,

the Driver UI will be displayed. First, set driver to 'Advanced'

(Dropdown

1), and then navigate to the following tabs

for your installed scanner(s).

ix) Locate the 'Color Correction' drop-down. There are two choices

available:

"Monitor" uses Gamma tables optimized for LCD display and should

be used for image archiving.

"Printer" uses Gamma tables optimized for reproduction and

recommended for use with FreeFlow MakeReady in a production

print environment.

Page 3

DocuMate

Scanners and Xerox

(shown below)

FreeFlow MakeReady

x) Select the Color Correction best suited to your work environment,

and click 'Save'.

Note:

If using flatbed and ADF scanners, it is advisable to

set the Color Correction the same for both.

xi) Once testing has been concluded, and your scanners are working

as expected, you can either combine the scanners as shown in the

next section, or move directly to the last section.

3. Combining Scanner Drivers

i) This can only be achieved after completing section '2. Driver

Installation'. If you are not using a flatbed scanner, or wish to keep

the scanners drivers separate then this section can be skipped.

ii) Depending on your Operating System, navigate to the

corresponding hardware device page in the Windows Control Panel.

For Windows XP and Windows Vista

Navigate to

"Scanners and Cameras"

window

Right-click on the flatbed

scanner, and select

'Properties'

For Windows 8 and Windows 7

Navigate to "Devices and

Printers" window

Right-click on the flatbed

scanner, and select 'Scan

Properties'