Xerox Nuvera 100 보충 설명서 - 페이지 28

{카테고리_이름} Xerox Nuvera 100에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Nuvera 100 48 페이지. Production system
Xerox Nuvera 100에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 기능 설명서 (34 페이지), 계획 매뉴얼 (22 페이지), 사용자 설명서 (40 페이지), 운영 매뉴얼 (34 페이지), 참조 매뉴얼 (2 페이지), 계획 매뉴얼 (20 페이지), 참조 매뉴얼 (42 페이지), 빠른 참조 (2 페이지), 설치 매뉴얼 (2 페이지), 계획 매뉴얼 (38 페이지), 계획 매뉴얼 (16 페이지), 참조 매뉴얼 (2 페이지), 사양 (2 페이지), 힌트 및 팁 매뉴얼 (18 페이지), 힌트 및 팁 매뉴얼 (18 페이지), 시작하기 매뉴얼 (26 페이지), 시작하기 매뉴얼 (30 페이지)

페이지 인쇄
Xerox Nuvera 100 보충 설명서
Managing and printing jobs from the Tape Client
Saving a tape
client setup

Preparing to print a tape job

Importing resource files

2-4
You can save a tape client setup including the following areas of
the Tape Client window:
•
Input Device
•
Output Control
•
End of Job
•
Document
To save a tape client setup:
•
Click Save Setup in the Job Setup area to save the setup
under its current name, or
•
Click Save As... in the Job Setup area to save the setup
under a new name.
To delete a tape client setup, click Delete.
This section describes tasks that you perform to access the Tape
Client and set up a tape job for printing.
NOTE: The parameters that you specify on the Tape Client
window override the settings of the queue to which the job is
sent.
In order to print a job from tape, the resources (forms, fonts,
JDLs, JDEs, etc.) that are required by the job must be loaded in
the "lcds" resources folder on the DP 2000 Series EPS system
disk. If any of the resources that are needed for your job are
missing from this folder, you must import them from the media on
which they reside (diskette, tape, or another folder in the UNIX
file system on the DP EPS controller). To import resource files to
the "lcds" folder:
1. Click Administration on the DocuSP Print Services window.
2. Click the Lcds Resources tab to display the list of resources
that are currently in the "lcds" folder.
Tape Client Job Submission Guide