Xerox Phaser 6100DN 사용자 설명서 - 페이지 7

{카테고리_이름} Xerox Phaser 6100DN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 6100DN 32 페이지. Disk overwrite installation and usage
Xerox Phaser 6100DN에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 사양 (2 페이지), 브로셔 및 사양 (4 페이지), 사용자 설명서 (28 페이지), 설치 매뉴얼 (2 페이지), 보안 매뉴얼 (38 페이지), 설치 매뉴얼 (2 페이지), 릴리스 노트 (2 페이지), 시작하기 매뉴얼 (37 페이지), 매뉴얼 (34 페이지), 매뉴얼 (34 페이지), 시작하기 매뉴얼 (34 페이지), 사용자 설명서 (32 페이지), 설치 및 운영 매뉴얼 (8 페이지)

Xerox Phaser 6100DN 사용자 설명서

Remote Services network configuration

User Guide
2
How do I start using Remote
Services?
After your Xerox customer representative installs and configures
Remote Services, you can immediately access the Home page.
The Home page provides links to all application features included
within Remote Services.
NOTE: For Remote Services registration information, please refer
to the Remote Services Setup Guide.
You can use the following links to access topics discussed in this
section:
Remote Services network configuration
User access
Launching the Remote Services application
Home page navigation
Before Remote Services is ready to provide full service, settings
for your network configuration need to be verified by your Xerox
customer service representative. If your system uses a proxy
server, settings to enable the network connection are defined as
follows:
1. Open the [Remote Services Home: Setup: Network
Settings] page.
2. Enter the HTTP Proxy Server, HTTP Proxy Port, user name
and password.
3. Click [Apply New Settings].
Additionally, your customer service representative must verify
settings for IP Address, Netmask, Gateway and DNS Host on the
[Remote Services Home: Setup: Network Settings] page. As
these settings are read-only in the Remote Services application,
the settings are edited through FreeFlow Print Server Setup.
Once these settings are configured, Remote Services is ready to
provide full network service.
Or, click Restore Settings if you do not want to modify the
capture settings and you want to restore the settings that were
saved last.
3