Xerox Phaser 6100DN User Manual - Page 7

Browse online or download pdf User Manual for Print Server Xerox Phaser 6100DN. Xerox Phaser 6100DN 32 pages. Disk overwrite installation and usage
Also for Xerox Phaser 6100DN: Installation Manual (34 pages), Specifications (2 pages), Brochure & Specs (4 pages), User Manual (28 pages), Install Manual (2 pages), Security Manual (38 pages), Install Manual (2 pages), Release Note (2 pages), Getting Started Manual (37 pages), Manual (34 pages), Manual (34 pages), Getting Started Manual (34 pages), User Manual (32 pages), Installation And Operation Manual (8 pages)

Print Page

User Guide

How do I start using Remote

Services?

After your Xerox customer representative installs and configures

Remote Services, you can immediately access the Home page.

The Home page provides links to all application features included

within Remote Services.

NOTE: For Remote Services registration information, please refer

to the Remote Services Setup Guide.

You can use the following links to access topics discussed in this

section:

Remote Services network configuration

User access

Launching the Remote Services application

Home page navigation

Before Remote Services is ready to provide full service, settings

for your network configuration need to be verified by your Xerox

customer service representative. If your system uses a proxy

server, settings to enable the network connection are defined as

follows:

1. Open the [Remote Services Home: Setup: Network

Settings] page.

2. Enter the HTTP Proxy Server, HTTP Proxy Port, user name

and password.

3. Click [Apply New Settings].

Additionally, your customer service representative must verify

settings for IP Address, Netmask, Gateway and DNS Host on the

[Remote Services Home: Setup: Network Settings] page. As

these settings are read-only in the Remote Services application,

the settings are edited through FreeFlow Print Server Setup.

Once these settings are configured, Remote Services is ready to

provide full network service.

Or, click Restore Settings if you do not want to modify the

capture settings and you want to restore the settings that were

saved last.