Alderon Industries Versa'larm VA01A 운영, 유지보수 및 설치 매뉴얼
{카테고리_이름} Alderon Industries Versa'larm VA01A에 대한 운영, 유지보수 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alderon Industries Versa'larm VA01A 4 페이지. 1 zone alarm
Alderon Industries Versa'larm VA01A에 대해서도 마찬가지입니다: 운영, 유지보수 및 설치 매뉴얼 (4 페이지)
페이지 인쇄
Versa'larm
1-Zone Alarm - Model VA01A
Operation, Maintenance and Installation Manual
Introduction of Installation
Safety Guidelines
1. DISCONNECT ALL ELECTRICAL SERVICE BEFORE INSTALLING OR WORKING ON THE PRODUCT.
2. DO NOT USE WITH FLAMMABLE OR EXPLOSIVE FLUIDS SUCH AS GASOLINE, FUEL OIL, KEROSENE, ETC.
DO NOT USE IN EXPLOSIVE ATMOSPHERES.
3. ALARM PANEL MUST BE MOUNTED INDOORS. FOR OUTDOOR APPLICATIONS CONSULT FACTORY.
Description of Operation
The 1-Zone Versa'larm™ alarm panel is powered by 120 VAC coming from standard wall outlets and is transformed to
9-11.1 VDC. Installing a 9 Volt battery provides battery backup during power outages. The power LED (green) will illuminate
when powered. The Versa'larm™ is a multipurpose alarm panel that can be use in a variety of applications such as: septic
tanks, sumps, holding tanks, pump chambers, water tanks, flow, pressure, condensate, temperature, and any others where
a "dry contact" can be connected to the alarm panel.
When a switch (signaling device) contact "closes" the buzzer will annunciate, alarm LED (red) will illuminate, and the built in
auxiliary contacts will be activated. The signaling device could be a float switch, water sensor, or sump probe sensor. The
auxiliary contacts can be used to connect to an Alderon Industries Auto Dialer, an existing alarm security system, or building
automation system (BAS).
Pressing the "Alarm Silence" pushbutton will silence the buzzer and the alarm LED (red) remains on. When the alarm condi-
tion is cleared, the system automatically resets itself for the next alarm cycle.
Tools, Supplies and Requirements for Installation - Not Included
1. Phillips screw driver
2. (Qty 2) #6 self tapping screws
3. Access to 120 VAC power receptacle
4. Optional - Plastic anchors (#8; Qty 2) if mounting to sheet rock
5. Optional - 9V battery (used for battery backup during power outages)
6. Optional - Wire stripper (used if you need to strip wire to connect to a BAS or SCADA system)
7. Optional - Needle nose pliers if using auxiliary contacts
Alarm Systems
Control Panels
Alderon Industries - Hawley, MN | 218.483.3034 | [email protected] | alderonind.com
™
Before proceeding with the installation or operation of the product, read all
instructions thoroughly, as well as complying with all federal, state and local
codes, regulations, and practices. The product must be installed by qualified
personnel familiar with all applicable local electrical and mechanical codes.
Refer to the National Electrical Code (NFPA 70). Failure to properly install and
test this product can result in personal injury or equipment malfunction.
Float Switches
Leak Detection Systems
P/N: 101444
Page 1 of 4