eControls Comfort365 C365C32 설치 관리자 매뉴얼 - 페이지 2

{카테고리_이름} eControls Comfort365 C365C32에 대한 설치 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. eControls Comfort365 C365C32 8 페이지. Wiring hub, model wh11 and wh32
eControls Comfort365 C365C32에 대해서도 마찬가지입니다: 설치 관리자 매뉴얼 (4 페이지)

페이지 인쇄

SEPARATE THE C365 SUBBASE

Place a slotted screwdiriver in the slots as shown and rotate to

remove subbase from the C365 housing.

ATTACH THE SUBBASE TO THE WALL

Attach the subbase to an interior wall and about 5-feet above

the floor as shown using the screws and wall anchors supplied.

The wiring to the HVAC equipment passes through the opening

next to the terminals.

5 V

G N D

S A

S B

C 3 6 5

C 3 2

INSTALL TWO AA BATTERIES

The batteries power the clock when 24VAC power is lost. Slide

the battery cover downward and install the two AA batteries as

shown.

INSTALL UPSTAIRS & DOWNSTAIRS DAMPERS

Refer to the WH11 or WH32 Wiring Hub Installation manual for

instructions on wiring dampers to the wiring hub.

Install an R80CJ damper in the duct supplying air to the upstairs.

Install a second R80CJ damper in the duct supplying air to the

downstairs. Each damper uses 2.4VA of power.

When two or more dampers are required to define the upstairs or

downstairs zones, the second damper may be plugged into the

connector marked OUT on the first damper. LEDS on the

damper actuator indicate when the damper is fully open (green)

or fully closed (red).

Ensure that damper installation does not cause

obstruction to the damper blade.

INSTALL UPSTAIRS TEMPERATURE SENSOR

Refer to the WH11 or WH32 Wiring Hub Installation manual for

instructions on wiring upstairs temperature sensors to the wiring

hub or connecting wireless sensors to the wiring hub.

Wired Sensors: One or two wired temperature sensors can be

installed and the temperatures are averaged. Model TS510W is

used for single sensor installations. Model TS520W is used for

dual sensor installations.

Wireless Sensors: One or two wireless temperature sensors can

be installed and the temperatures are averaged. Wireless

sensors require Model ELR1 plug in radio module. The radio

module plugs into the WH11 or WH32 wiring hub.

Green LED

Red LED