Direct Supply ZERO OPENING ASSIST 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Direct Supply ZERO OPENING ASSIST에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct Supply ZERO OPENING ASSIST 12 페이지. Device

Tools Required:

• 19 mm combination wrench or socket wrench

• 8 mm Allen wrench (hex wrench)

• 3 mm Allen wrench (hex wrench)

1. Verify your bed has 1/2" or

device mounting holes available.

•

Do not use the Direct Supply

WARNING:

Zero Opening Assist Device if your bed is not

designed to receive assist devices via the

required sized holes.

2. Align the assist device mounting plate with the

mounting holes in your bed deck. Ensure there

are two slots in the assist device mounting plate

which align with your bed's mounting holes.

Note about hole placement: The mounting slots on your assist device are not evenly spaced,

and your assist device can be mounted with either set of slots facing either direction (right or left).

If setting up devices on both sides of a bed, align slots so assists on opposite sides of the bed

are oriented as mirror images of each other. Additionally, check the orientation of the assist when

installing the assist for the first time; the position of the assist can be adjusted 1" to 2" by rotating

the mounting plate 180 degrees before installation.

16"

•

Do not use the Direct Supply Zero Opening Assist Device if the slots do not align

WARNING:

with your bed's assist device mounting holes.

Installation

⁄

" diameter assist

18"