Direct Supply ZERO OPENING ASSIST 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Direct Supply ZERO OPENING ASSIST에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct Supply ZERO OPENING ASSIST 12 페이지. Device

3. Determine which direction(s) you want the

assist device to pivot (up, right, left).

4. Set the pivot lock by inserting one or two set screws into the pivot lock holes in the back of the assist

device mounting plate. See chart below for placement instructions:

To pivot to three positions:

Insert one set screw into

hole A (right hole with handle

pointing up) using a 3 mm

Allen (hex) wrench. Fully insert

but do not tighten.

* NOTE – hole placement on

BACK of assist device

•

Do not allow the assist device to pivot in all four directions. Allowing the device to pivot

WARNING:

toward the floor may potentially create a crush hazard and/or damage to your bed.

To pivot to two positions:

Insert one set screw into hole

A and one set screw into

either hole D or hole B (will

prevent pivoting in the opposite

direction of screw placement).

Fully insert but do not tighten.

* NOTE – hole placement on

BACK of assist device

To use as non-pivoting assist:

Insert one set screw into hole

B and one set screw into hole

D using a 3 mm Allen (hex)

wrench. Fully insert but do

not tighten.

+ A

* NOTE – hole placement on

BACK of assist device

1-800-634-7328

and

DirectSupply.com