ALDERWOOD Cyclops 매뉴얼 - 페이지 5

{카테고리_이름} ALDERWOOD Cyclops에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALDERWOOD Cyclops 8 페이지. Hand crafted sound

WIRING

The Cyclops is supplied with a short length of cable designed to be

soldered onto for long lasting performance in harsh outdoor environ-

ments. It is recommended to properly cover the soldered joint with

glued heatshrink to keep moisture out of the joint.

We recommend speaker cable thickness of 12-16g speaker cable be

used. On long cable runs up to 80 meters we recommend 12g cable

be used to avoid voltage drop. In humid or salt air environments

tinned copper properly sealed with heat shrink over any joins will

resist corrosion and provide better signal integrity for many years

longer than standard copper.

PARALLEL WIRING

The Cyclops subwoofer is an 8ohm amplifier load and as such 2 units

can be wired in parallel and connected to a 4 ohm compatible

amplifier and be driven off a single amplifier channel. It is

recommended that speaker cable lengths be as equal as possible

when running them in parallel. Both subwoofers must be the

Alderwood Cyclops, no other subwoofer can be wired from the same

amplifier channel.

___________________________________________________

The Cyclops subwoofer has 16 mounting points that can be utilised

when installing the subwoofer. A minimum of 4 points should be

used at all times.

NOTE

All 16 threaded mounting points must have a fastener securely in

place to maintain cabinet pressure. Running this subwoofer with

missing bolts or air leaks will result in damage to the driver and

potentially allow water ingress voiding your warranty.