ALDERWOOD Cyclops 매뉴얼 - 페이지 6
{카테고리_이름} ALDERWOOD Cyclops에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALDERWOOD Cyclops 8 페이지. Hand crafted sound
페이지 인쇄ATTACHING THE FEET
The 4 feet provided with the cyclops can be attached to the front
or the rear of the subwoofer depending on how you are using it.
To attach the feet undo the 4 M5 countersunk screws and bolt
the feet in place using the removed bolts, be sure to make sure
the feet are firmly in place to prevent any air or water leaks if
outside.
___________________________________________________
TROUBLE SHOOTING
Sound is crackly
or
distorted at low
volume
Speaker sounds
distorted at high
volume
No sound
- Check solder joint for a potential short.
- Ensure amplifier terminals are
done up tightly.
- Check the wiring going into
amplifier for shorts.
- Check the crossover settings on your
amplifier are correctly set
-Check amplifier power is capable of
250-500w at 8 ohm to adequately
power the Cyclops with enough headroom
-Check amplifier gain setting is not
set too high, if required have the head
unit signal set at no more than 3/4 of
max volume for a clean peak free signal
- Check all connections
right input.
- Check power