ALDERWOOD Cyclops Manuel - Sayfa 6

Subwoofer ALDERWOOD Cyclops için çevrimiçi göz atın veya pdf Manuel indirin. ALDERWOOD Cyclops 8 sayfaları. Hand crafted sound

ATTACHING THE FEET

The 4 feet provided with the cyclops can be attached to the front

or the rear of the subwoofer depending on how you are using it.

To attach the feet undo the 4 M5 countersunk screws and bolt

the feet in place using the removed bolts, be sure to make sure

the feet are firmly in place to prevent any air or water leaks if

outside.

___________________________________________________

TROUBLE SHOOTING

Sound is crackly

distorted at low

volume

Speaker sounds

distorted at high

volume

No sound

- Check solder joint for a potential short.

- Ensure amplifier terminals are

done up tightly.

- Check the wiring going into

amplifier for shorts.

- Check the crossover settings on your

amplifier are correctly set

-Check amplifier power is capable of

250-500w at 8 ohm to adequately

power the Cyclops with enough headroom

-Check amplifier gain setting is not

set too high, if required have the head

unit signal set at no more than 3/4 of

max volume for a clean peak free signal

- Check all connections

right input.

- Check power