Yamaha AvantGard N3 유지 관리 핸드북 - 페이지 28

{카테고리_이름} Yamaha AvantGard N3에 대한 유지 관리 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AvantGard N3 45 페이지. Hybrid piano

NU1

5. Key Stopper Rail

Remove the left/right screws [S2NC] (one each) and the two hex nuts [28], and the two plastic washers [26], and remove the

key stop rail.

* Be careful not to lose any of the damper holder spacers when attaching or removing the key stop rail.

* Adjust the height of the key stop rail assembly by increasing or decreasing the number of damper holder spacers.

6. Key Block

Remove each of the two screws [S2E], and remove the L and R key blocks.

7. Key Sensor

7-1

Remove all the keys.

* Be careful not to damage the key shutters attached to the keys when installing or removing the keys.

7-2

Remove the eight (8) screws marked [230]. The key sensor unit can then be removed.

* Place a mark of the key sensor unit on the keybed before removal and make sure to install it at the original position.

[S2NC]

DAMPER HOLDER SPACER

[S2E]

KEY BLOCK L

KEY SENSOR UNIT

[230]

[26], [28]

KEY STOPPER RAIL ASSEMBLY

KEYS

[S2NC]

DAMPER HOLDER SPACER

[S2E]

KEY BLOCK R

[230]

KEYBED

Marking