Yamaha disklavier DKC-850 연결 매뉴얼 - 페이지 3
{카테고리_이름} Yamaha disklavier DKC-850에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha disklavier DKC-850 6 페이지. Internet connection guide
Yamaha disklavier DKC-850에 대해서도 마찬가지입니다: 데이터 목록 (16 페이지), 기능 설명서 (13 페이지), 업데이트 매뉴얼 (5 페이지), 업데이트 매뉴얼 (45 페이지), 인터넷 연결 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (22 페이지)
페이지 인쇄
Important
• Be sure to backup the data on your existing control unit to a floppy disk before connecting.
• Please keep your original control unit for future maintenance.
1
Turn on your piano, and reset settings on your control unit
to its factory default.
For details on setting, refer to your piano's owner's manual.
2
Turn off your piano, and disconnect the power cable from
the AC wall outlet.
3
Disconnect the control cable from the TO CONTROL
CABLE FOR PIANO connector on the rear panel of your
control unit.
Loosen the two screws attached to the connector using a
screwdriver.
4
Connect the supplied conversion cable to the control cable
disconnected in step 2.
Tighten the two screws attached to the connector using a
screwdriver.
5
Connect the supplied conversion cable to the TO PIANO
connector on the rear panel of DKC-850.
Tighten the two screws attached to the connector using a
screwdriver.
6
Connect monitor speakers to the OUTPUT jacks on the rear
panel of DKC-850.
7
Connect the supplied AC adaptor to the DC-IN 12V
connector on the rear panel of DKC-850.
8
Connect the supplied power cable to the AC adaptor.
9
Connect the power cable extended from your piano and the
AC adaptor to the AC wall outlet.
The connection completed.
Turn on DKC-850, and set the piano type.
3
Note:
The location of the TO CONTROL
CABLE FOR PIANO connector
varies depending on the piano model.
Attention:
DKC-850 does not work properly if
the control cable is connected
directly to it. Use the supplied
conversion cable to connect your
piano and DKC-850.
See "Connecting Monitor Speakers"
on page 4.
See "Setting the Type of Your Piano"
on page 5.