Yamaha REVSTAR 소유자 매뉴얼 - 페이지 11
{카테고리_이름} Yamaha REVSTAR에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha REVSTAR 15 페이지.
Yamaha REVSTAR에 대해서도 마찬가지입니다: 소유자 매뉴얼 (14 페이지)
- 1. Table of Contents
- 2. Precautions
- 3. Tuning Machine Tension Adjustment
- 4. HEIGHT ADJUSTABLE LOCKING NUT (if Applicable)
- 5. Setting the String Action
- 6. VIBRATO SYSTEM Vintage Type
- 7. VIBRATO SYSTEM Locking Type
- 8. Bridge/Spring Tension Adjustments
- 9. Truss Rod Adjustment
- 10. Pickup Height Adjustment
When changing strings it is necessary to cut off the ball ends of
the strings.
Following is the procedure for changing strings and adjusting the
vibrato system:
1) Loosen the three clamp screws (A).
2) Turn the peg to loosen the string being replaced.
3) Loosen the lock screw (B) of the string being replaced.
4) Remove the old string.
5) Tighten the lock screw to lock the string in place, then roughly
tune the string. Do not over tighten the lock screw. Over tight-
ening may result in damage.
6) Make sure that the fine tuning screw (C) is in the middle of its
range of travel.
7) After tuning, rock the tremolo arm back and forth about three
times then re-tune the instrument.
8) If necessary, adjust the intonation and bridge angle.
9) Tighten the three clamp screws (A) to lock the strings at the nut.
10) Use the fine-tuning screws (C) to precisely tune the instrument
to the correct pitch.
VIBRATO SYSTEM Locking Type
Intonation Adjustment in Vibrato Bridge
1) After loosening/detuning the strings you would like to adjust.
Loosen the hexagonal screw (D) located in the front of each
saddle using the supplied hexagonal wrench.
2) Slide the saddles by hand to adjust the length of each string.
3) When the intonation is correct, tighten the hexagonal screw (D)
in front of each saddle to ensure that its position stays stationary.
10