Yamaha YPT-370 서비스 매뉴얼 - 페이지 15

{카테고리_이름} Yamaha YPT-370에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YPT-370 44 페이지.

Removing the Spring Terminals

Spring terminal A and spring terminal B (Time required: About 8 minutes)

1. Remove the lower case assembly. (See procedure 1)

2. Remove the BATT ribbon cable soldered to spring terminals A and B. (Fig.9)

3. Flip over the lower case assembly, and remove the battery cover assembly. (Fig.1)

4. Spring terminal A is removed by slowly lifting upward and then sliding to the top right. (Fig.9)

5. To remove spring terminal B, release the hook, and pull it out from the inside. (Fig.9)

Spring terminal C and spring terminal D (Time required: About 1 minute each)

1. Remove the battery cover assembly. (See "●Spring terminal A and spring terminal B" in procedure 8)

2. Release the hooks, and pull out spring terminals C and D. (Fig.9)

SPRING TERMINAL B

接点バネB

CONNECTER

半田付け

SOLDERING

ASSEMBLY

BATT束線

BATT

接点バネD

SPRING TERMINAL D

フック

HOOK

フック

接点バネA

SPRING TERMINAL A

Fig.9

PSR-E373/YPT-370

接点バネD

SPRING TERMINAL D

接点バネC

SPRING

TERMINAL C