Yamaha YT2030MS 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Yamaha YT2030MS에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YT2030MS 9 페이지. Vibraphone, metallophone

페이지 인쇄

10.Insert the resonators into the grooves of the side

frame at the treble side.

When attaching the bass side of resonators, pass the edge

of the resonators through the grooves in the middle of reso-

nator holders from below. If the temperature is 23°C or

more, use the shallow grooves A; or if the temperature is

below 23°C, use the deeper grooves B, to get optimal reso-

nance.

NOTE

• Due to the structure of the instrument, the resonators

(both natural tone and accidental tone) can only be

installed in the correct position.

Resonators

Resonator

holder

The bass side

of the resonators

11.

Adjust the instrument height.

Pulling up the lever on the left and right leg raises the height

away from the floor, while pressing the instrument strongly

from above while pulling up the lever lowers it toward the

floor. When you release the lever, the instrument height is

fixed at that height.

NOTE

• The legs have a scale that serves as a guide for adjust-

ing the height.

• We recommend that you lower the height slightly more

than you intend, and then make minor adjustments

while raising it little by little.

• Adjust the left and right height at the same time to keep

the level of the tone bars.

• Grease is applied to the cylinders of the legs to change

the instrument height smoothly. If grease is sticks to

your hand, rinse it with running water.

• Unbackle the damper belt when you re-adjust the instru-

ment height.

12.Adjust the depth of the pedal pressing.

Unbuckle the damper belt, adjust the position of the pedal,

and then fix it by buckling the belt.

Damper pedal

3–4 cm

Floor

13.Make sure that all screws on each part are tight-

ened securely.

The assembly is now complete.

YV2030MS YT2030MS Owner's Manual • 7

Assembly

Lever