Yamaha YV-3710 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Yamaha YV-3710에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YV-3710 28 페이지. Concert vibraphones
Yamaha YV-3710에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지), 소유자 매뉴얼 (29 페이지), 소유자 매뉴얼 (34 페이지)

페이지 인쇄

BEFORE PLAYING

Power Supply

Prepare the supplied AC adapter.

* Make sure to use the supplied AC adapter. Use of different adapters may cause damage not

covered by the warranty.

Connect the small plug of the AC adapter to the DC 12V IN jack on the controller.

Plug the AC adapter into a power outlet.

Controller

MOTOR OUT

DC 12V IN

PAUSE MEMORY FUNCTION SETTING (YV-3910/3710/3700 only)

The YV-3910, YV-3710 and YV-3700 are equipped with a PAUSE MEMORY FUNCTION which

stops the fan always in exactly the same position when it is turned off (no vibrato applied).

After connection to an AC outlet, set the PAUSE MEMORY to the desired fan stop position as

follows:

Turn the controller power ON.

Press the START/STOP button once to start the fan, and

then press the START/STOP button once again to stop

the fan.

Remove the synchro belt by sliding it off the fan side

pulley, as shown in the illustration. Position the fan verti-

cally (fan position with strongest resonator effect) and

remount the belt.

Perform this setting for both the natural and the acciden-

tal tone side.

: YV-3910/3710/3700/2700/2700G/1600A/520

AC Adapter

Set the fan to a vertical

position.

Fan

Resonator

* Wrapping the AC adapter

cord once around one of

the legs will prevent

accidental disconnection of

the adapter plug.

Slide belt

Fan Side Pulley

Synchro Belt

off.