Yamaha piaggero NP-31 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Yamaha piaggero NP-31에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha piaggero NP-31 28 페이지. Quick operation guide
Yamaha piaggero NP-31에 대해서도 마찬가지입니다: 참조 (7 페이지), 빠른 작동 매뉴얼 (2 페이지)

페이지 인쇄

Combining Voices (Dual)

You can play Voices simultaneously across the entire range of the keyboard. In this way, you can combine similar

Voices to create a thicker sound.

Press two Voice buttons simultaneously to engage Dual.

The Voice assigned to the left side button will be designated as Voice 1, and the

Voice assigned to the right side button will be designated as Voice 2.

Using Variation Voices in Dual mode

To select a Variation Voice in Dual mode, first select the desired Voice, then

press the [VARIATION] button. Finally, press the two desired Voice buttons

simultaneously. If either of the Voices is a Variation Voice, the [VARIATION]

indicator lights. To use (or cancel) Variation for both Voices, simply press the

[VARIATION] button so that the indicator lights (or goes off).

To exit from Dual, press one of the Voice buttons.

Setting the Octave

While holding down the [VARIATION] button, press one of the C4 – D4 keys

to shift the pitch up or down in octave steps for Voice 1.

While holding down the [VARIATION] button, press one of the D#4 – F4 keys

to shift the pitch up or down in octave steps for Voice 2.

Voice 1

C#4

Setting the Volume Balance

While hold down the [VARIATION] button, press one of the F#4 – F#5 keys

(see the illustration) to adjust the volume balance between two Voices. A set-

ting of "0" produces equal balance between Voices 1 and 2. Values below "0"

(to "-6") decrease the volume of Voice 1 and increase the volume of Voice 2;

values above "0" (to "6") increase the volume of Voice 1 and decrease the vol-

ume of Voice 2.

Voice 1 Voice 2

-1

D#4

Voice 2

F#4 (-6)

NP-31

NP-11

-1

NP-31

NP-11

F#5 (+6)

C5 (0)

NP-31/NP-11 Owner's Manual

Selecting & Playing Voices

NOTE

Dual mode cannot be used with two

Voices of the single Voice button (for

example, strings and vibraphone).

NOTE

Reverb in Dual

The reverb type assigned to Voice 1 will

take priority. If the reverb assigned to

Voice 1 is set to OFF, the reverb assigned

to Voice 2 will be in effect.

NOTE

Refer to "Selecting Voices" on page 10 for

more information on the Voices that are

assigned to the [VARIATION] button.