Yamaha Reface DX 참조 매뉴얼 - 페이지 5

{카테고리_이름} Yamaha Reface DX에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Reface DX 11 페이지.
Yamaha Reface DX에 대해서도 마찬가지입니다: 업데이터 매뉴얼 (8 페이지)

페이지 인쇄
Yamaha Reface DX 참조 매뉴얼

Setting the EG (envelope generator)

You can adjust the shape of the envelopes applied to the operators by using the [EG level] and [EG
rate] buttons. Volumes and modulation degrees are set on the EG Level screen; rates of change
are set on the EG Rate screen.
Level
Key on

EG Level

EG levels can be set between "0" (minimum) and "127" (maximum) for each operator.
For carriers, these levels set the volume; for modulators, they set the degree of modulation.
1.
Press the [EDIT] button to activate Edit mode.
2.
Press the [EG level] button.
The EG Level Settings screen is displayed.
3.
If necessary, press the [EG level] button several times to switch between operators.
4.
Change the settings for Level 1 to Level 4 by using the sliders.
5.
If necessary, alternately use the [EG level] and [EG rate] buttons to adjust the overall shape of the envelope.
6.
When you have finished making settings, press the [EDIT] button once again to leave Edit mode.

EG Level Settings screen

1
2
3
1
Level 1
2
Level 2
3
Level 3
4
Level 4
Level 1
Level 2
Rate 1
Rate 2
Rate 3
4
Attack level
Decay level
0 to 127
Sustain level
Release level
For settings other than "0" , the sound will stop when it reaches the Level 4 setting.
Level 3
Level 4
Rate 4
Key off
Time
reface Reference Manual
5