Yamaha Aventage RX-A3040 추가 정보 - 페이지 2
{카테고리_이름} Yamaha Aventage RX-A3040에 대한 추가 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Aventage RX-A3040 8 페이지. About dolby atmos
Yamaha Aventage RX-A3040에 대해서도 마찬가지입니다: 빠른 매뉴얼 (8 페이지), 설정 매뉴얼 (2 페이지), 설정 매뉴얼 (2 페이지), 간편한 설정 매뉴얼 (2 페이지)
Dolby Enabled SP
Select this option when using the Dolby Enabled speakers as the presence speakers.
It utilizes sounds reflected from ceiling and lets you enjoy overhead sounds only from
speakers that are placed at the same level as traditional speakers.
• Place the Dolby Enabled speakers on top of or near the traditional speakers (front, surround or surround
back speakers). A Dolby Enabled speaker unit may be integrated into a traditional speaker. For details,
refer to the instruction manual of the Dolby Enabled speakers.
b Connecting speakers
When using two presence speakers, connect them to the F.PRESENCE (EXTRA SP1)
speaker terminals. When using four presence speakers, connect front presence
speakers to the F.PRESENCE (EXTRA SP1) speaker terminals and rear presence
speakers to the R.PRESENCE (EXTRA SP2) speaker terminals.
❑ Speaker settings
Follow the procedure below to configure the speaker setting in the "Setup" menu.
1
Press ON SCREEN on the remote control.
2
Select "Setup" ➞ "Speaker" ➞ "Manual Setup" ➞ "Configuration"
and set "Front Presence" to "Large" or "Small".
If you are using rear presence speakers, also set "Rear Presence" to
"Large" or "Small".
• It makes no difference if you select "Large" or "Small". This setting will be automatically adjusted by
YPAO.
2
En
Front presence
Rear presence
3
Select "Layout" and check that "Surround" is set to "Rear".
• Virtual CINEMA FRONT does not support playback of Dolby Atmos contents.
4
Select the presence speaker layout in "Front Presence".
If you are using rear presence speakers, also select its layout in
"Rear Presence".
• When using Dolby Enabled speakers, be sure to select "Dolby Enabled SP" before performing YPAO.
c Optimizing the speaker settings automatically (YPAO)
Refer to Owner's Manual and perform YPAO.
d Starting playback
Follow the procedure below to play back Dolby Atmos contents.
1
Press SUR.DECODE on the remote control repeatedly to select
"bSurround" as the surround decoder.
2
Start playback of the Dolby Atmos content on your video device.
• To check if the Dolby Atmos decoder is working, view the information on the front display (Audio
Decoder) or TV.
This completes all the preparations. Enjoy Dolby Atmos contents with the unit.