Yamaha A-670 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Yamaha A-670에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha A-670 47 페이지.

페이지 인쇄

TROUBLESHOOTING

Problem

Only the speaker on one side can be

heard.

There is a lack of bass and no ambience.

A "humming" sound can be heard.

The sound level is low.

(A-U670 only) The BASS, TREBLE, and

BALANCE controls does not work.

(A-U670 only) The connected PC does not

recognize this unit.

(A-U670 only) Noisy playback.

(A-U670 only) The sound is interrupted.

(A-U670 only) Music files cannot be

played.

Cause

Incorrect cable connections.

Incorrect setting for the BALANCE control.

(When a subwoofer is connected.)

The subwoofer is not properly connected.

The + and – wires are connected in reverse at the amplifier or the

speakers.

Incorrect setting for the BASS control.

Incorrect cable connections.

The volume of the unit is set to a low level.

(A-U670 only) The volume of the PC connected with the unit via

USB is set to a low level.

The PURE DIRECT function is turned on.

The operating system of the PC is not supported.

Improper USB cable connection.

The output of the PC or application is muted.

Another application is launched on the PC while a music file is

being played.

(If another application is launched while a music file is being

played, sound may be momentarily lost or noise may be generated.)

Another application is launched on the PC while a music file is

being played.

(If another application is launched while a music file is being

played, sound may be momentarily lost or noise may be generated.)

The music data are not properly reproduced, because this unit is

connected to the PC or the input of this unit is switched to USB

while the music application is running on the PC.

The dedicated "Yamaha HiFi USB Driver" has not been installed

correctly.

The audio output destination of the computer is not set to "Yamaha

A-U670/A-U671."

Solution

Connect the cables properly. If the problem persists, the cables may be

defective.

Set the BALANCE control to the appropriate position.

Connect the cables properly. If the problem persists, the setting for the

subwoofer may be incorrect.

Connect the speaker wires to the correct + and – phase.

Set the BASS control to the appropriate position.

Connect the audio plugs firmly. If the problem persists, the cables may be

defective.

Turn up the volume with the VOLUME control so that you can hear

sound.

Turn up the volume of the PC.

Turn off the PURE DIRECT function.

Use a PC with an operation-guaranteed operating system.

Connect the USB cable properly.

Cancel the sound muting of the PC or application.

Do not launch other applications during playback.

Connect this unit to the PC and set the input of the unit to USB in

advance. Then launch the music application and start playback.

Install the "Yamaha HiFi USB Driver" again by following the correct

procedure.

Set the audio output destination of the computer to "Yamaha A-U670/A-

U671."

See page