Yamaha AX-497 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Yamaha AX-497에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AX-497 23 페이지. Stereo amplifier
Yamaha AX-497에 대해서도 마찬가지입니다: 서비스 매뉴얼 (36 페이지), 소유자 매뉴얼 (24 페이지)

페이지 인쇄

Remove approximately 10 mm (3/8 in) of

insulation from the end of each speaker

cable and twist the exposed wires of the

cable together to prevent short circuits.

10 mm (3/8 in)

Unscrew the knob.

Insert one bare wire into the hole in the side

of each terminal.

Tighten the knob to secure the wire.

Red: positive (+)

Black: negative (–)

Red: positive (+)

Black: negative (–)

Red: positive (+)

Black: negative (–)

■ Connecting the banana plug

(With the exception of Asia, Korea, U.K. and

Europe models)

First, tighten the knob and then insert the banana plug into

the end of the corresponding terminal.

Banana plug

Notes

• One or two speaker sets can be connected to this unit. If you use

only one speaker set, connect it to either the SPEAKERS A or B

terminals.

• Use speakers with the specified impedance shown on the rear

panel of this unit.

CONNECTIONS