Yamaha CX-1000 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Yamaha CX-1000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha CX-1000 20 페이지. Natural sound stereo control amplifier
Yamaha CX-1000에 대해서도 마찬가지입니다: 소유자 매뉴얼 (21 페이지), 소유자 매뉴얼 (20 페이지), 서비스 매뉴얼 (38 페이지)

페이지 인쇄

SAFETY INSTRU

Keep this manual in a safe place for future

reference.

Avoid placing your CX-1000 in direct sunlight

or close to a source of heat. Also avoid lo-

cations in which the device is likely to be

subjected to excessive dust, cold or mois-

ture.

The openings on the cabinet ensure the

ventilation of the amplifier. If these openings

are obstructec, the temperature inside the

cabinet will rise rapidly and eventually

damage the circuits. Therefore, avoid plac-

ing objects against these openings and do

not install your amplifier in a place such that

the flow of air through the ventilation

openings could be impeded.

Power cord

When removing the power plug from the wall

outlet, always pull directly on the plug. Never

yank the cord as this may result in damage

to the cord and possibly a short-circuit.

lf you do not intend to use this unit for an

extended period of time, it is advisable to

unplug the power cord.

Switches and knobs

Avoid applying excessive force to the

switches and knobs.

E Relocation

Before moving your amplifier, be sure to

unplug the power cord and remove all other

connecting cables.

@ Troubleshooting Chart

Consult the Troubleshooting Chart for advice

on the common

operation errors before

concluding that your amplifier is faulty.

E Servicing

Do not open the cabinet or attempt to make

repairs by yourself, as this may aggravate

the damage and expose you to an electrical

shock.

Object and liquid entry

See to it that foreign objects or spilled liquids

do not enter inside the cabinet. Should this

case arise, consult your YAMAHA dealer.

Wipe off dust with a dry soft cloth. To remove

dirt or fingermarks, use a soft damp cloth

then dry immediately with a clean cloth.

not use alcohol, thinners or other chemical

solvents since they may damage the finish

or remove the panel lettering.

Do not use any aerosol sprays near this unit

as these products can easily get into the unit

and damage the circuitry.

VOLTAGE SELECTOR

(General Model only)

The voltage selector switch on the CX-1000

rear panel must be set for your local voltage

BEFORE plugging in the AC mains supply.

Voltages are 110/120, 220/240V AC, 50/60Hz.

110V~120V

220W-240VW

VOLTAGE

SELECTOR

Special instructions

for the U.K.

THE WIRES IN THE MAINS LEAD ARE

COLOURED IN ACCORDANCE WITH THE

FOLLOWING CODE:

Blue: NEUTRAL

Brown: LIVE

As the colours of the wires in the mains

lead of this apparatus may not correspond

with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured BLUE must be

connected to the terminal which is marked

with the letter N or coloured BLACK. The

wire which is coloured BROWN

must be

connected to the terminal which is marked

with the letter L or coloured RED.