Clark & Clark Speciality Products P1060 설치 지침

{카테고리_이름} Clark & Clark Speciality Products P1060에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark & Clark Speciality Products P1060 2 페이지. Self-triggering prop for mgb trunk lid or hood and mg midget trunk lid

페이지 인쇄

Self-Triggering Prop Installation Instructions

For MGB Trunk Lid or Hood and MG Midget Trunk Lid

Note: these props replace factory-original telescoping props on MGs (approx. 1971 - 1980).

They will not replace the manual props found on earlier vehicles.

1. Remove the old prop. Save the nuts and bolts. (Nuts should be locknuts).

2. Orient the self-triggering prop so that the wide channel attaches to the car body, and the

narrow channel attaches to the trunk lid (or hood, if you are installing the hood prop). Make

sure you orient each bolt as shown in the sketch. (If this is not done, the prop will not have

enough clearance to collapse and you might damage your trunk lid or your hood!). Close your

trunk lid or hood slowly to make sure everything operates smoothly.

Note: safety pin holes are provided on these props. When in the open/latched position, a safety

pin may be inserted through the inner and outer channels to prevent inadvertent unlatching of the

prop (use this in windy weather!).

#P1033, P1059, P1060