Clark Synthesis TACTILE SOUND TST329 설치 매뉴얼 - 페이지 6

{카테고리_이름} Clark Synthesis TACTILE SOUND TST329에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Synthesis TACTILE SOUND TST329 20 페이지. Platinum, gold, silver and all weather transducers
Clark Synthesis TACTILE SOUND TST329에 대해서도 마찬가지입니다: 데이터시트 (1 페이지)

페이지 인쇄

1. Supplied Parts

Installation: Overview

Installation Type: Unimount Bracket

Screws into the bottom of the mounting surface.

Requires access only to the bottom of the mounting

surface. Requires a flat or nearly flat mounting surface.

Minimum 4-1/2" vertical space required,

including 1/2" clearance between the

Transducer and the floor.

3/4"-thick

mounting

surface

Unimount

Bracket

Flat Washer

Lock Washer

Screw

Jam Nut (up)

Transducer Lead Wire

Tactile Sound Transducers

NEVER TIGHTEN

BY TURNING THE

TRANSDUCER.

MAKE SURE TO

TIGHTEN THE JAM

NUT AGAINST THE

TRANSDUCER'S

BRASS NUT

3/8"-16

Threaded Stud

Jam Nut (down)

Washers

Screw

Jam Nuts

Installation Type: Hanger Bolt

Screws into the bottom of the mounting surface (into a

5/16" drilled hole. Requires access only to the bottom

of the mounting surface.

Minimum 3-1/2" vertical space required,

including 1/2" clearance between the

Transducer and the floor.

Minimum

3/4"-thick

Transducer Lead Wire

Tip: Tighten

two Jam Nuts

against each

other to screw

in Hanger Bolt

using wrench.

Joist

(edge view)

Drill 5/16" hole

3/8"-16

Hanger Bolt

Jam Nut (down)

Jam Nut