Clark Synthesis TACTILE SOUND TST329 설치 매뉴얼 - 페이지 7
{카테고리_이름} Clark Synthesis TACTILE SOUND TST329에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Synthesis TACTILE SOUND TST329 20 페이지. Platinum, gold, silver and all weather transducers
Clark Synthesis TACTILE SOUND TST329에 대해서도 마찬가지입니다: 데이터시트 (1 페이지)
페이지 인쇄Installation Type: T-Nut
Requires initial access to the top of the material to
insert the T-Nut, which installs flush to the surface.
(Drill a 7/16" hole for the T-Nut.)
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Flat Washer
Lock Washer
Transducer Lead Wire
www.clarksynthesis.com
Drill 7/16" hole
T-Nut
NEVER TIGHTEN
BY TURNING THE
Jam Nut (up)
TRANSDUCER.
MAKE SURE TO
3/8"-16
TIGHTEN THE JAM
Threaded Stud
NUT AGAINST THE
Jam Nut (down)
TRANSDUCER'S
BRASS NUT
Washers
Jam Nuts
Installation: Overview
Installation Type: Hex Bolt
For use with metal or other high-tensile mounting
surfaces no thicker than 1/4". Requires access to the
top of the mounting surface both to install the bolt and
to tighten it.
Minimum 3-1/4" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Maximum 1/4"-thick
mounting
surface
Lock Washer
Transducer Lead Wire
Tactile Sound Transducers
Drill 7/16" hole
3/8"-16
Hex Bolt
Flat Washer
Jam Nut (up)
Jam Nut (down)
Flat Washer
Lock Washer
Jam Nuts
7