Clark Synthesis TACTILE SOUND TST329 Installatiehandleiding - Pagina 7
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Clark Synthesis TACTILE SOUND TST329. Clark Synthesis TACTILE SOUND TST329 20 pagina's. Platinum, gold, silver and all weather transducers
Ook voor Clark Synthesis TACTILE SOUND TST329: Gegevensblad (1 pagina's)
Pagina afdrukkenInstallation Type: T-Nut
Requires initial access to the top of the material to
insert the T-Nut, which installs flush to the surface.
(Drill a 7/16" hole for the T-Nut.)
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Flat Washer
Lock Washer
Transducer Lead Wire
www.clarksynthesis.com
Drill 7/16" hole
T-Nut
NEVER TIGHTEN
BY TURNING THE
Jam Nut (up)
TRANSDUCER.
MAKE SURE TO
3/8"-16
TIGHTEN THE JAM
Threaded Stud
NUT AGAINST THE
Jam Nut (down)
TRANSDUCER'S
BRASS NUT
Washers
Jam Nuts
Installation: Overview
Installation Type: Hex Bolt
For use with metal or other high-tensile mounting
surfaces no thicker than 1/4". Requires access to the
top of the mounting surface both to install the bolt and
to tighten it.
Minimum 3-1/4" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Maximum 1/4"-thick
mounting
surface
Lock Washer
Transducer Lead Wire
Tactile Sound Transducers
Drill 7/16" hole
3/8"-16
Hex Bolt
Flat Washer
Jam Nut (up)
Jam Nut (down)
Flat Washer
Lock Washer
Jam Nuts
7