Directed DB3 403.KIA8 설치 매뉴얼 - 페이지 5

{카테고리_이름} Directed DB3 403.KIA8에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed DB3 403.KIA8 20 페이지. 2020 kia forte5 (smart key)

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the "Vehicle connections" following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory

hood pin, or if not supported in data.

[2] Tach:

The tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[3] Resistor: The resistor value can be anywhere between 5K and 10K.

403.KIA8 1.07 2020 Kia Forte5 (Smart Key)

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation