Clark Synthesis TACTILE SOUND AQ339 Aquasonic 설치 매뉴얼 - 페이지 8

{카테고리_이름} Clark Synthesis TACTILE SOUND AQ339 Aquasonic에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 12 페이지. Underwater speaker
Clark Synthesis TACTILE SOUND AQ339 Aquasonic에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지), 사양 (1 페이지), 부품 목록 (1 페이지), 사용자 설명서 (1 페이지), 참조 시트 (1 페이지), 설치 매뉴얼 (3 페이지), 사양 (1 페이지), 설치 매뉴얼 (20 페이지)

페이지 인쇄
Clark Synthesis TACTILE SOUND AQ339 Aquasonic 설치 매뉴얼
IN-WALL INSTALLATION
Carefully remove the speaker from its box. Install the mounting gasket around the rubber ring of
1
the sound lens (as shown below). Insure the mounting gasket is installed evenly and is firmly seated
against the entire circumference of the sound lens.
Place the speaker on a non-abrasive surface with the sound lens facing up. Hold the face ring above the
2
sound lens, allowing the clamp tabs to fall open. Set the face ring against the mounting gasket, insuring
each clamp tab is on the outside of the mounting gasket. Hold the entire assembly together and place
it on the non-abrasive surface as shown in the third picture below. Carefully position the sound lens so
it is centered over the face ring.
Pull the bundled speaker wire through the wire clamp. Place the wire clamp under each clamp tab,
3
verifying the nut and bolt adjuster is accessible when the clamp is placed under the tabs. Insure the
mounting gasket and face ring are still evenly centered.
8
www.clarksynthesis.com
Underwater Speaker