Clark Synthesis TACTILE SOUND AQ339 Aquasonic Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Głośniki Clark Synthesis TACTILE SOUND AQ339 Aquasonic. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 12 stron. Underwater speaker
Również dla Clark Synthesis TACTILE SOUND AQ339 Aquasonic: Podręcznik uzupełniający (4 strony), Specyfikacje (1 strony), Lista części (1 strony), Podręcznik użytkownika (1 strony), Arkusz referencyjny (1 strony), Instrukcja instalacji (3 strony), Specyfikacja (1 strony), Instrukcja instalacji (20 strony)

IN-WALL INSTALLATION

Carefully remove the speaker from its box. Install the mounting gasket around the rubber ring of

the sound lens (as shown below). Insure the mounting gasket is installed evenly and is firmly seated

against the entire circumference of the sound lens.

Place the speaker on a non-abrasive surface with the sound lens facing up. Hold the face ring above the

sound lens, allowing the clamp tabs to fall open. Set the face ring against the mounting gasket, insuring

each clamp tab is on the outside of the mounting gasket. Hold the entire assembly together and place

it on the non-abrasive surface as shown in the third picture below. Carefully position the sound lens so

it is centered over the face ring.

Pull the bundled speaker wire through the wire clamp. Place the wire clamp under each clamp tab,

verifying the nut and bolt adjuster is accessible when the clamp is placed under the tabs. Insure the

mounting gasket and face ring are still evenly centered.

www.clarksynthesis.com

Underwater Speaker