Clark Synthesis TACTILE SOUND AQ339 Aquasonic 설치 매뉴얼 - 페이지 10

{카테고리_이름} Clark Synthesis TACTILE SOUND AQ339 Aquasonic에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 20 페이지. Underwater speaker
Clark Synthesis TACTILE SOUND AQ339 Aquasonic에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지), 사양 (1 페이지), 부품 목록 (1 페이지), 사용자 설명서 (1 페이지), 참조 시트 (1 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (3 페이지), 사양 (1 페이지)

페이지 인쇄

Clark Synthesis TACTILE SOUND AQ339 Aquasonic 설치 매뉴얼

IN-WALL INSTALLATION

Place the wire clamp under each clamp tab, verifying the nut and bolt adjuster is accessible when

the clamp is placed under the tabs. Insure the mounting gasket and face ring are still evenly

centered. Use a wrench and a Phillips screwdriver to tighten the wire clamp. When fully tightened,

the wire clamp should be firmly seated in each clamp tab and the speaker should be secure. Pick

up the assembly and insure it is still properly centered in the face ring. If not, loosen the wire

clamp and adjust.

Take the end of the speaker wire and pull it through the conduit hole in the back of the niche. For

future speaker servicing, leave enough speaker wire in the niche to allow the speaker to be placed

on the pool deck.

Note: In actual applications, the niche will already be mounted in the wall of the pool.

Diluvio

Underwater Speaker

™