Clark Synthesis TST429 설치 매뉴얼 - 페이지 6
{카테고리_이름} Clark Synthesis TST429에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clark Synthesis TST429 20 페이지. Platinum, gold, silver and all weather transducers
Clark Synthesis TST429에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (1 페이지), 구매자 매뉴얼 (2 페이지), 사양 (1 페이지), 설치 매뉴얼 (20 페이지)
페이지 인쇄
Installation: Overview
Installation Type: Unimount Bracket
Screws into the bottom of the mounting surface.
Requires access only to the bottom of the mounting
surface. Requires a flat or nearly flat mounting surface.
Minimum 4-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Unimount
Bracket
Flat Washer
Lock Washer
Screw
Jam Nut (up)
Transducer Lead Wire
6
Tactile Sound Transducers
NEVER TIGHTEN
BY TURNING THE
TRANSDUCER.
MAKE SURE TO
TIGHTEN THE JAM
NUT AGAINST THE
TRANSDUCER'S
BRASS NUT
3/8"-16
Threaded Stud
Jam Nut (down)
Washers
Screw
Jam Nuts
Installation Type: Hanger Bolt
Screws into the bottom of the mounting surface (into a
5/16" drilled hole. Requires access only to the bottom
of the mounting surface.
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Minimum
3/4"-thick
Transducer Lead Wire
Tip: Tighten
two Jam Nuts
against each
other to screw
in Hanger Bolt
using wrench.
Joist
(edge view)
Drill 5/16" hole
3/8"-16
Hanger Bolt
Jam Nut (down)
Jam Nut
www.clarksynthesis.com