Directed Xpresskit DBALL2 설치 매뉴얼 - 페이지 7

{카테고리_이름} Directed Xpresskit DBALL2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Xpresskit DBALL2 18 페이지. Ford5 remote start ready (rsr) installation
Directed Xpresskit DBALL2에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (18 페이지), 매뉴얼 (14 페이지), 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (15 페이지), 설치 및 빠른 참조 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (16 페이지), 매뉴얼 (19 페이지), 설치 매뉴얼 (11 페이지), 설치 매뉴얼 (10 페이지)

페이지 인쇄

Platform: DBALL2

Firmware:

HYUNDAI9 Remote Start Ready (RSR) Installation

SmartStart/XL202 Installation Notes

The DBALL2 Remote Start Ready (RSR) solution offers three (3) configuration options to control your system: 3x OEM

Lock Remote Start Activation, RF Kits or SmartStart (all sold separately). This section provides specific installation

information for SmartStart and XL202.

SmartStart Revision A

SmartStart is optional and not included. It MUST be purchased separately.

Configuration Wires (White & Brown or Blue)

DBALL2

CABLE

D2D (4 pins, white)

The modules must be connected in a specific order. Refer to the Module Programming section for more information.

SmartStart Revision B

SmartStart is optional and not included. It MUST be purchased separately.

DBALL2

CABLE

D2D (4 pins, white)

The modules must be connected in a specific order. Refer to the Module Programming section for more information.

RF Kit

The optional XL202 and antenna are not included and MUST be purchased separately.

DBALL2

XOVER

1. Use the D2D Crossover (XOVER) cable that is provided with XL202, and NOT the one in the DBALL2 package.

2. The modules must be connected in a specific order. Refer to the Module Programming section for more information.

RF Kit & PKE Combination

Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.

RF Kit, PKE & SmartStart BT Combination

Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.

Cut Brown or Blue Loop

4 pins

2 pins,

not used

Configuration Wires (Gray & White)

Connect Gray wire to (-) Ground

5 pins

4 pins

2 pins,

not used

LED

XL202

Prog.

Button

SmartStart

LED

THIS SIDE UP

Rev.: 20161206

Page 7