ACOPOWER HY-SPKP-200W30A 사용자 설명서 - 페이지 12

{카테고리_이름} ACOPOWER HY-SPKP-200W30A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACOPOWER HY-SPKP-200W30A 17 페이지. Solar panel kits

The adapter kits have different lengths, and the basic size is No. 12 AWG. It is suitable for

parallel connection of 100W / 200W / 300W / 400W / 500W solar panels.

The typical connection for 12V panels using a MPPT Controller is a parallel

connection. This connection increases the current, but keeps the voltage level the

same. When placing multiple panels in parallel, it is necessary to size the wire.

Please refer to Figure 3. This figure shows the extending of the output wires of the

ACOPOWER-100W Solar Panel using the adapter kit. The polarity labeled on the panel's

leads should be the only ones to follow. When adapting the leads, mark the positive (+)

cable; doing so will avoid reverse polarity when connecting the panel(s) to the controller.

Solar Panel to Charge Controller

Use a screwdriver to connect the bare end of the red positive pole line of the MC4

extension cord to PV+ "o" of the MPPT charging controller, and the bare end of the black

negative pole line of the MC4 extension cord to pv-" o "of the MPPT charging controller.

Figure 3 Solar panel and adapter kit

Address:4120 Valley Blvd, Walnut CA 91789, USA

MC4

Call: (626) 575-7722

Web:www.acopower.com