ACOPOWER HY-SPKP-200W30A Kullanıcı Kılavuzu - Sayfa 12
Solar panel ACOPOWER HY-SPKP-200W30A için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ACOPOWER HY-SPKP-200W30A 17 sayfaları. Solar panel kits
Sayfayı Yazdır
The adapter kits have different lengths, and the basic size is No. 12 AWG. It is suitable for
parallel connection of 100W / 200W / 300W / 400W / 500W solar panels.
The typical connection for 12V panels using a MPPT Controller is a parallel
connection. This connection increases the current, but keeps the voltage level the
same. When placing multiple panels in parallel, it is necessary to size the wire.
Please refer to Figure 3. This figure shows the extending of the output wires of the
ACOPOWER-100W Solar Panel using the adapter kit. The polarity labeled on the panel's
leads should be the only ones to follow. When adapting the leads, mark the positive (+)
cable; doing so will avoid reverse polarity when connecting the panel(s) to the controller.
Solar Panel to Charge Controller
Use a screwdriver to connect the bare end of the red positive pole line of the MC4
extension cord to PV+ "o" of the MPPT charging controller, and the bare end of the black
negative pole line of the MC4 extension cord to pv-" o "of the MPPT charging controller.
Figure 3 Solar panel and adapter kit
Email: [email protected]
Address:4120 Valley Blvd, Walnut CA 91789, USA
MC4
11
Call: (626) 575-7722
Web:www.acopower.com