Clarke 6500005 운영 및 유지 관리 지침 - 페이지 11

{카테고리_이름} Clarke 6500005에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6500005 19 페이지. Mortising machine

PREPARING FOR USE

Make sure the machine is disconnected from the mains supply before

performing checks, adjustments, or setup procedures.

INSTALLING CHISEL AND BIT

The chisel and drill bit are extremely sharp...take care when handling!

Open the cover...at either side, by

pulling down on the plastic

catch,to expose the chuck.

10. Insert the drill bit into the chisel then

insert the chisel and bit up through

the hole in the head.

Push the chisel up as far as possible

into the head, and nip up the grub

screw to temporarily hold it in this

position, using the hex. wrench

provided.

You can lower the drill bit gently, and

allow it to rest on the table whilst

carrying out this operation.

NOTE:

The opening in the side of the chisel

should always be to the right or left,

never to the front or rear. The opening

allows chips to escape during

operation. See 'Adjusting Chisel

Parallel to Workpiece' on page13.

WARNING:

CAUTION!