Clarke 6500005 Інструкція з експлуатації та обслуговування - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Електроінструмент Clarke 6500005. Clarke 6500005 19 сторінок. Mortising machine
Друкувати сторінку
PREPARING FOR USE
Make sure the machine is disconnected from the mains supply before
performing checks, adjustments, or setup procedures.
INSTALLING CHISEL AND BIT
The chisel and drill bit are extremely sharp...take care when handling!
9.
Open the cover...at either side, by
pulling down on the plastic
catch,to expose the chuck.
10. Insert the drill bit into the chisel then
insert the chisel and bit up through
the hole in the head.
Push the chisel up as far as possible
into the head, and nip up the grub
screw to temporarily hold it in this
position, using the hex. wrench
provided.
You can lower the drill bit gently, and
allow it to rest on the table whilst
carrying out this operation.
NOTE:
The opening in the side of the chisel
should always be to the right or left,
never to the front or rear. The opening
allows chips to escape during
operation. See 'Adjusting Chisel
Parallel to Workpiece' on page13.
WARNING:
CAUTION!
9
10
11