Clarke 6500010 운영 및 유지 관리 지침 - 페이지 4

{카테고리_이름} Clarke 6500010에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6500010 14 페이지. Mortising machine

22. HANDLE WITH EXTREME CARE Whenever transporting or installing machinery, and

always use a lifting tool wherever possible.

23. AVOID ACCIDENTAL STARTING. Ensure the switch is OFF before plugging in to mains.

24. BE AWARE that accidents are caused by carelessness due to familiarity. ALWAYS

concentrate on the job in hand, no matter how trivial it may seem.

ADDITIONAL SAFETY INSTRUCTIONS for MORTISING

1. DO NOT USE until unit is completely assembled and installed according to these

instructions.

2. IF YOU ARE NOT thoroughly familiar with the operation of mortising machines, obtain

advice from a qualified person.

3. ENSURE the machine is secured to a workbench to prevent it from tipping over during

operation.

4. NEVER TURN MORTISING MACHINE ON before clearing the table of all objects (tools,

scrap pieces, etc.).

5. ALWAYS KEEP hands, fingers and hair away from the rotating bit.

6. DO NOT ATTEMPT to mortise materials that do not have a flat surface, unless a suitable

support is used.

7. ALWAYS use 'Hold Down' to prevent the work from lifting when withdrawing the chisel.

ALWAYS SUPPORT workpiece securely against fence to prevent rotation.

9. ENSURE the drill bit is sharp, undamaged and properly secured in the chuck before use.

10. ENSURE the chuck key is removed before starting.

11.

NEVER START the Machine with the drill bit or chisel pressed against the workpiece.

12. NEVER PERFORM LAYOUT, assembly or set-up work on the Machine with the cutting

tool rotating.

13.

ALWAYS ADJUST DEPTH STOP to avoid drilling into the table.

14. ALWAYS STOP the machine before removing scrap pieces from the table.

15. SHUT OFF POWER, remove the drill bit and chisel and clean the table before leaving

the machine.

16. DO NOT WEAR gloves, neckties or loose fitting clothing. Long hair should be contained.

17. NEVER OPERATE the Machine if any part is damaged or broken.

18. NEVER PLACE YOUR FINGERS in a position where the drill or cutting tool could contact

them if the workpiece should shift unexpectedly.

19. ALWAYS DISCONNECT the machine from the electrical supply before changing the

chisel and bit, and before any cleaning or maintenance.

MACHINES