Clarke 6500010 Instruções de funcionamento e manutenção - Página 4
Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Ferramenta eléctrica Clarke 6500010. Clarke 6500010 14 páginas. Mortising machine
Imprimir página
22. HANDLE WITH EXTREME CARE Whenever transporting or installing machinery, and
always use a lifting tool wherever possible.
23. AVOID ACCIDENTAL STARTING. Ensure the switch is OFF before plugging in to mains.
24. BE AWARE that accidents are caused by carelessness due to familiarity. ALWAYS
concentrate on the job in hand, no matter how trivial it may seem.
ADDITIONAL SAFETY INSTRUCTIONS for MORTISING
1. DO NOT USE until unit is completely assembled and installed according to these
instructions.
2. IF YOU ARE NOT thoroughly familiar with the operation of mortising machines, obtain
advice from a qualified person.
3. ENSURE the machine is secured to a workbench to prevent it from tipping over during
operation.
4. NEVER TURN MORTISING MACHINE ON before clearing the table of all objects (tools,
scrap pieces, etc.).
5. ALWAYS KEEP hands, fingers and hair away from the rotating bit.
6. DO NOT ATTEMPT to mortise materials that do not have a flat surface, unless a suitable
support is used.
7. ALWAYS use 'Hold Down' to prevent the work from lifting when withdrawing the chisel.
8.
ALWAYS SUPPORT workpiece securely against fence to prevent rotation.
9. ENSURE the drill bit is sharp, undamaged and properly secured in the chuck before use.
10. ENSURE the chuck key is removed before starting.
11.
NEVER START the Machine with the drill bit or chisel pressed against the workpiece.
12. NEVER PERFORM LAYOUT, assembly or set-up work on the Machine with the cutting
tool rotating.
13.
ALWAYS ADJUST DEPTH STOP to avoid drilling into the table.
14. ALWAYS STOP the machine before removing scrap pieces from the table.
15. SHUT OFF POWER, remove the drill bit and chisel and clean the table before leaving
the machine.
16. DO NOT WEAR gloves, neckties or loose fitting clothing. Long hair should be contained.
17. NEVER OPERATE the Machine if any part is damaged or broken.
18. NEVER PLACE YOUR FINGERS in a position where the drill or cutting tool could contact
them if the workpiece should shift unexpectedly.
19. ALWAYS DISCONNECT the machine from the electrical supply before changing the
chisel and bit, and before any cleaning or maintenance.
MACHINES
5