Clarke 7640115 사용자 지침 - 페이지 5

{카테고리_이름} Clarke 7640115에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7640115 13 페이지. Sand blast cabinet

ASSEMBLY

NOTE: PTFE tape is provided for use to ensure an airtight fit.

1. Lay the cabinet on its back and

attach the four legs using the M6

x12mm screws, flat washers and

nuts, ensuring the flat washers are

against the screw heads.

2. Fit the intake vent cover to the

cabinet.

3. Attach the pick-up tube to the

funnel as shown, using the M6 x

12mm screws provided.

4. If not already fitted, peel the

backing paper from the foam strip

and apply the strip to the edge of

the grid support. Trim the strip

accordingly.

5. Use a punch (or similar) to make

holes in the foam strip, at the bolt

holes.

6. Place the grid support on the

funnel flange and the grid into the

recess in the grid support, so that the pick-up tube protrudes through the

grid neatly. Do not use undue force.

7. Turn the cabinet on to its legs then

and with assistance, raise the

funnel to meet the underside of

the cabinet, ensuring the pickup

tube is at the front of the cabinet.

Bolt the funnel assembly to the

cabinet using the M6 x 20mm

screws with the nuts and flat

washers provided, ensuring the

flat washers are against the screw

heads.

8. Open the cabinet door and attach the air hose from the gun to the inlet

port on the front of the cabinet, then connect the pick-up hose from the

gun to the pick-up tube attached to the funnel, securing with the worm

drive clip provided.

9. Attach the shelf to the legs using the screws and nuts provided.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]