Clarke 7640115 사용자 지침 - 페이지 6

{카테고리_이름} Clarke 7640115에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7640115 13 페이지. Sand blast cabinet

OPERATION

Plug the transformer into the power

supply and switch the power ON.

Switch the lamp ON by pushing the

rocker switch on the switch box 'I'.

Switch OFF by pushing 'O'.

Ensure all air connections are secure,

and the pick up is correctly located

beneath the grid, before filling the

cabinet with abrasive media. Do not

fill higher than the level of the grid.

NOTE: PTFE tape is provided which may be used on the threads of the

various connectors to ensure an airtight connection.

Select the ceramic abrasive nozzle to produce the jet required for the

abrasive media being used, and assemble according to the instructions given

below.

Place the object to be cleaned in the cabinet, and close the lid, securing with

the swivel clip.

Turn on the extraction device which must be attached to the port on the left

side of the cabinet before turning on the air supply.

Set the pressure to the required value, but not higher than 100lbf/in

check to ensure there are no air leaks. Should there be any, turn off the air

supply and repair where necessary, before turning the supply back on. Pull the

trigger on the gun and proceed to blast the object to be cleaned.

Keep the jet facing the object and away from the clear plastic lid. Do not

allow the jet to train on the rubber gloves, the air hose within the cabinet or

the fluorescent lamp.

When completed, release the trigger then turn off the air supply. As a

precautionary measure, ALWAYS pull the trigger before opening the lid.

NOTE: There are no hard or fast rules governing nozzle sizes and air

pressures used with different abrasives. With experience and

experimentation you will quickly learn the best combinations for

the required result.

NOTE: On more delicate parts, start with minimal air pressure to avoid

unnecessary peaning or excessive abrasion, and work up to a

setting to produce the desired finish.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

, and